Is there any difference between seamless elbow and seamless pipeline? The answer must be different. So what is the main difference between the two?

　　 1. The master first talks about the craft:
The process of seamless elbow is hot pushing, cold pressing and hot pressing, and the process of seamless elbow is intermediate frequency bending, hot pressing and numerical control bending. Among them, carbon steel is a very commonly used seamless elbow in pressure pipes, alloy steel is hot push, stainless steel is cold push, and a very common process for seamless elbows is intermediate frequency bending.
　　 2. The difference in scouring power:
The R of seamless elbow and seamless pipeline itself is different. R is a position that controls the length of seamless elbow and seamless elbow. The scouring strength of small R passing through the medium must be much greater than that of large R, that is to say , The scouring strength of 1D seamless elbow is not as good as 1.5D seamless elbow. The scouring strength of 1.5D seamless elbow is lower than seamless elbow, and seamless elbow is more scour and wear than seamless elbow.
　　3. There is also a special case, such as bridges. It is necessary to use a large-span seamless elbow to cross over. At this time, seamless elbow can not be used, and general heat pipes also use seamless elbows.
Seamless elbows have different uses in different industries. It can freely extend to far places with the advantage of bending, and the strength of the building will also be reduced. Seamless elbows are widely used in electric power, petroleum, navigation, chemical and other fields. They are mainly used for oil transportation, natural gas transportation and liquid infusion. They play an important role in aircraft and their engines.